Audi Tail Light Repair – Intermittent LED or Signal Faults
From January 1st, 2026, we will be strictly Trade Only for New Zealand Info here
Price Exclusive of GST
Our minimum assessment fee is $150 + GST (Excluding Headlights) this just covers the time to check the unit over. If you go ahead with the repair, we’ll put this towards the total cost. Our full terms of trade is the link can be found here
International Customers:
When sending a unit from overseas, please declare it as “Repair and Return” with a low customs value (around $100 USD) to avoid unnecessary import fees. - All Repair Prices are quoted in NZD
Audi Tail Light Repair – Intermittent LED or Signal Faults
Restore Consistent Lighting | OEM LED Repair
This is a repair service for Audi tail lights that are experiencing intermittent function, such as brake lights, indicators, or running lights that cut in and out, flicker, or fail intermittently. These issues are typically caused by internal circuit or solder joint failure, not just the LEDs themselves.
Common Symptoms Repaired:
-
Tail light works intermittently or only when the vehicle is warm/cold
-
Flickering or dim segments
-
Indicators or brake lights fail randomly
-
Fault codes or dash warnings related to rear lights
-
Water or heat-related internal damage
What We Do:
-
Open the tail light housing and inspect internal boards
-
Reflow or replace faulty LEDs and solder joints
-
Repair or replace damaged driver circuits
-
Reseal the unit to prevent future moisture ingress
-
Full bench testing for consistent operation before return
Applies To:
-
Audi A3, A4, A6, Q5, Q7, and more
-
Factory-fitted LED tail lights (OEM only)
Turnaround Time: 2–4 business days
Warranty: 12 months on all repaired components
Price: On consultation – depends on model and condition
💡 Don’t settle for unreliable lighting — we bring your original Audi tail light back to life with precision, reliability, and tested results.
Disclaimer – Headlight & Tail Light Repairs
Please note: Headlights and tail lights are not designed by the manufacturer to be opened once assembled. While our team takes every possible precaution and uses specialist methods to carefully separate and reseal these units, there is always a risk of damage to the lens, housing, or clips during the process.
If a unit does break during disassembly, there may be no viable way to restore it to original condition. In such cases, we will advise you immediately, but we cannot accept liability for any damage that occurs as a result of necessary opening procedures.
Due to the additional time, skill, and equipment required, headlight repairs carry a higher minimum assessment fee to cover the work of our plastics specialist, including plastic welding, resealing, and reassembly.
By sending your headlight or tail light for repair, you acknowledge and accept these conditions.